Specifications

17
9.1.8 TP Scan
When you enter to “TP Scan” menu, there will
display the screen like below:
1 In “Satellite” item, press[Volume Up/ Volume
Down]key to switch satellite that you want to
scan or press[OK]key to enter satellite list for
selection.
2 In “TP Index” item, you not only can use
[Volume Up/ Volume Down]key to select
transponder but also can
use[Add]and[Delete]functions.
 When you press[Green] key, it will display
“New Carrier” in “TP Index” item; You
should set the parameters of “TP
Frequency” and “Symbol Rate” for this new
transponder. The parameters of “TP
Frequency” and “Symbol Rate” can set by
number keys. The available range are
“3000~13450 MHz” and
“1000~45000Ks/s”.
 When you press[Yellow] key, there will
show up a warning message for reminding
whether you will delete the current
transponder or not. If you select “Yes”, the
current transponder will be deleted, and
the total account of transponder will reduce
1 correspondingly.
3 For the existed transponder, you also can
use number keys to modify the parameters
of “TP Frequency” and “Symbol Rate” or
press[Volume Up/ Volume Down]key to
switch it directly.
4 “Polarity” and “Scan Mode” are use for
setting scans conditions, you can
press[Volume Up/ Volume Down]key to
select different mode. “Polarity” means you
want to scan this TP in horizontal mode or
in vertical mode. “Scan Mode” means you
want to scan all channels or only scan free
channels.
5 When you complete your modification,
press [Red] button, it will show up a dialog
to ask you scan mode, program type and
NIT Search on/off. After you set up, press
[OK] key to start scanning.
6 In the “TP Scan” item, press [Exit] key to
exit the scanning and save the current
parameters.
9.1.9 Single Search
1 Press [Left/Right] key to select search
mode. Quick means preset scan, that is
searching the existed TP. Detail means
blind scan. It is no need existed TP info.
2 Press [OK] key, it will show up a dialog to
ask you scan mode, program type and NIT
Search on/off. After you set up, press [OK]
key to start scanning.
9.10 Multi Search
1 Multi Search can support search the multi
satellite one by one as user select.
2 Press [green] key to select search mode.
Quick means preset scan, that is searching
the existed TP. Detail means blind scan. It
is no need existed TP info.
3 Press [OK] key, it will show up a dialog to
ask you scan mode, program type and NIT