Specifications

7
4. Front panel
STANDBY/ON: To switch the receiver power on/stand by
MENU (Optional): To enter into the main menu.
▲,▼ KEY (optional):To change channels, or to move cursor up or down in the menu
VOL ◄,► (Optional): To adjust volume level, or to move cursor left or right in the menu
OK KEY (Optional): To see TV/Radio channel list, or to confirm in the menu.
Remote Sensor: Detects infrared signal from remote control unit
Display(4-Digit/7-Segment) (Optional): Indicates operating status of receiver
Red Power Led: When receiver is in standby mode, red power led is lighted.
Green Signal Led: When received signal is strong, the signal led is lighted.
Smart Card Slot (Optional): One or two (optional) slots CA Interface for Conax.
5. Rear Panel
Please refer to the diagram below for all possible connections of your receiver
Do not connect the unit to the mains socket until all other connections have been made and
checked.
LNB IN 13/18V 500mA MAX: This port is to connect the coaxial cable from LNB of your Dish.
LOOP: This enables the connection of another receiver.
VIDEO : This RCA connector is used to connect any external video.
AUDIO R/L : These RCA connectors are used to connect any external audio amp or system.
TV : This is used to connect your TV through SCART cable.
RS 232C SERIAL PORT: This is used to connect your receiver to a computer through a serial cable
RF IN (optional):
Analog TV antenna connection.
RF OUT (optional): To connect the TV via RF cable.
0/12V: This is used to Connect 12V to an external 0V/12V switch
S/PDIF (optional): digital audio connection, connect the amplifier with S / PDIF input.