User's Manual

Introduction
Version 0.5
AMIMON Confidential 9
Small mechanical footprint:
With PCB integrated antennas
RF characteristics:
MIMO technology, using 5GHz unlicensed band, 18MHz bandwidth.
Coexists with 802.11a/n and 5.8GHz cordless devices.
Support for Automatic Transmission Power Control (ATPC).
No line of sight needed between transmitter and receiver. It has a range of over 30 meters, suitable for
almost any room.
14mW typical transmission power of the uplink channel.
Maximum 45mW transmission power of the uplink channel.
Minimum -65 dBm received signal power for successful operation
Current consumption
Option to to disable 40MHz digital clock to AMN2210 from AMN3210.
Power requirements:
3.3V (±5%), ~4.2W
Certification & Compliance:
FCC
This product is for indoor use only in the band of 5.15-5.25GHz.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by Amimon for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
MIC
This device has complied with Japan Radio law:
Item 19-11 of Article 1 paragraph 1 of certification ordinance.
Item 19-3 of Article 1 paragraph 1 of certification ordinance.