User's Manual
Table Of Contents
- 1. Purpose
- 2. The System
- 3. Setting-up a Link
- 4. System Configuration
- 5. User Interface
- 5.1 Video Input selection
- 5.2 Video input status Tx & Rx
- 5.3 Registration (both Tx and Rx)
- 5.4 Association (Tx & Rx)
- 5.5 RF frequencies table selection
- 5.6 Manual Transmission power (Tx only)
- 5.7 Manual frequency selection
- 5.8 Broadcast mode (both Tx and Rx)
- 5.9 Link exists (both Tx and Rx)
- 5.10 Communication error (both Tx and Rx)
- 5.11 DVI mode (Rx Only)
- 6. Basic Troubleshooting
WHDI Reference Design Setup Guide
Dev Kit-UG1_Rev 1.0.28
Confidential Under NDA
Internal document. Information subject to change
10 Page
Note: To ensure optimal performance please make sure that the antennas are not
blocked by any object, both on Tx and Rx sides
2.2.2 Seagull Rx Interface Board
The Seagull Rx Interface board is used to interface to the various displays and
destinations of the wireless link. It contains the following video and audio outputs:
HDMI output
Stereo I
2
S audio (optional)
Optical SPDIF audio input (optional)
Seagull board is supporting the following Amimon’s wireless modules (same as fig
1.a):
- Shaldag (via J15)
- The board also contains a remote control IR receiver port (optional) that will
be supported with later SW versions.
- The power supply of the Sparrow board is 5V 2A center positive DC power.
2.2.3 User Interface board (AMN60)
See section 2.1.3 above