User's Manual
Table Of Contents
- 1. Purpose
- 2. The System
- 3. Setting-up a Link
- 4. System Configuration
- 5. User Interface
- 5.1 Video Input selection
- 5.2 Video input status Tx & Rx
- 5.3 Registration (both Tx and Rx)
- 5.4 Association (Tx & Rx)
- 5.5 RF frequencies table selection
- 5.6 Manual Transmission power (Tx only)
- 5.7 Manual frequency selection
- 5.8 Broadcast mode (both Tx and Rx)
- 5.9 Link exists (both Tx and Rx)
- 5.10 Communication error (both Tx and Rx)
- 5.11 DVI mode (Rx Only)
- 6. Basic Troubleshooting
WHDI Reference Design Setup Guide
Dev Kit-UG1_Rev 1.0.28
Confidential Under NDA
Internal document. Information subject to change
12 Page
4. System Configuration
4.1 Supported resolutions
The Sparrow system currently supports video formats up to and including:
720p 60fps
1080i 60fps
1080p 24fps/30fps
1080p 60fps
The system is configured to automatically recognize the resolution, and adjust
accordingly. Switching sources and resolutions once the link is set is legal, and the
system should adjust automatically, although this may result in a few frames of blank
video and may take a few seconds. The system is also capable of recognizing the
color space (RGB/YCbCr) and adjusting accordingly.
4.2 HDMI
To ensure full support and optimal performance, the HDMI (or DVI) source and
display connected to the WHDI Reference Design system should support EDID and
HDCP, and should provide the necessary 5V DC voltage as specified by the HDMI
requirements.