User's Manual
Table Of Contents
- 1. Purpose
- 2. The System
- 3. Setting-up a Link
- 4. System Configuration
- 5. User Interface
- 5.1 Video Input selection
- 5.2 Video input status Tx & Rx
- 5.3 Registration (both Tx and Rx)
- 5.4 Association (Tx & Rx)
- 5.5 RF frequencies table selection
- 5.6 Manual Transmission power (Tx only)
- 5.7 Manual frequency selection
- 5.8 Broadcast mode (both Tx and Rx)
- 5.9 Link exists (both Tx and Rx)
- 5.10 Communication error (both Tx and Rx)
- 5.11 DVI mode (Rx Only)
- 6. Basic Troubleshooting
WHDI Reference Design Setup Guide
Dev Kit-UG1_Rev 1.0.28
AMIMON
B1
B2
B3
L1
L1
L1
L1
L2
L2
L3
L4
L5 L6 L7
L8
L9 L10
Figure 6 - LEDs for System Error Indication
5.11 DVI mode (Rx Only)
In case the display has only a DVI port and the Rx is connected to a display via an
HDMI to DVI cable, you should set the Rx in DVI mode which removes the audio
from the link. This mode can also be used to mute an HDMI link.
o Button: A short press on B3 sets the Rx in DVI mode (default mode is HDMI). An
additional press returns the Rx to HDMI mode.
Confidential Under NDA
Internal document. Information subject to change
16 Page