User's Manual
Table Of Contents
- 1. Purpose
- 2. The System
- 3. Setting-up a Link
- 4. System Configuration
- 5. User Interface
- 5.1 Video Input selection
- 5.2 Video input status Tx & Rx
- 5.3 Registration (both Tx and Rx)
- 5.4 Association (Tx & Rx)
- 5.5 RF frequencies table selection
- 5.6 Manual Transmission power (Tx only)
- 5.7 Manual frequency selection
- 5.8 Broadcast mode (both Tx and Rx)
- 5.9 Link exists (both Tx and Rx)
- 5.10 Communication error (both Tx and Rx)
- 5.11 DVI mode (Rx Only)
- 6. Basic Troubleshooting
WHDI Reference Design Setup Guide
Dev Kit-UG1_Rev 1.0.28
Confidential Under NDA
Internal document. Information subject to change
7 Page
1. Purpose
This document explains the required steps needed for setting up a link with
AMIMON's WHDI
TM
Development Platform.
This is a basic user's guide that includes troubleshooting and a description of the
basic features of the system that should allow the user to establish a video link and
control the system
This document refers to systems running Shaldag with MAC version 3.0 and
on, with application (Seagull) version 1.4.25 and on.