User's Manual

Switching between transmitters
1. In order to switch between video transmitters, press the “SOURCE” button and a
menu will appear
2. Choose the desired transmitter using the up, down arrows, and “OK” buttons.
*Note this is a Unicast product, the desired transmitter must be disconnected from any
another system before being chosen.
3. The existing video link will be lost and within 30 seconds, the new transmitter will connect and
new video link will be established.
Multi-system operation
SkyLink supports multisystem mode, i.e. several pairs of receivers and transmitters can work
simultaneously. It is recommended to keep the pairs at least 1 meter away from each other.
Link drop
Likely causes for this might be:
1. Exceeded Range
To re-establish link bring systems back in to range.
2. Reset
To re-establish link in case Tx/Rx have been reset, it is necessary to reset both sides. In Aerial
mode both systems must be within 30 meters of each other. In Multi-monitor mode the systems
must be within the operating range defined in the spec.