User's Manual

Link Quality Indicator
The link quality indicator gives the user an indication of link quality.
When enabled this indicator appears in the top left corner in three different colors, depending on the
quality of the link:
- Very good
- Reasonably good
- Poor
In order to enable the indicator the user must short press the link quality button on the Receiver during
link. With a series of short presses the user can switch between several indication modes as described
in the flow chart below:
Note that the link quality indication button on the receiver is used for registration as well. During link a
long press will generate the registration message on the monitor.
Before a link is established:
This button is used solely for the registration process. See Registration section for correct usage.