Toure Fixed Shower Door with windowpane design Installation Instructions Size:39"x77"
●Please read these instructions in full before installation IMPORTANT ●Check that the shower surround has been installed to the manufacturer’s instructions. Please note - All product is supplied without a tray. ●Opening wall adjustments Adjustment =38.58"-38.97"x77"[(980-990)x1950mm] GENERAL SAFETY INSTRUCTIONS ● Do not fix the wall profile to newly plastered, painted or papered walls as chemical reaction may cause discoloration to the surface finish.
IDENTIFICATION OF PARTS 8FR02e 8FR02f 8FR07 8FR06 8FR02d 8FR02a 8FR01 8FR02b 8FR02c 8FR03 8FR08 8FR04 8FR05 2.5mm 3.
Fixings & fittings supplied Item No.: Part Quantity Item No.: Part Quantity 8FR01 X1 8FR04 8FR02a X1 8FR05 X6 8FR02b X1 8FR06 X1 8FR02c X1 8FR07 8FR02d X1 8FR08 X2 8FR09 8FR02f X1 8FR10 8FR03 X1 8FR02e ST4.0x30 ST4.0x30 ST3.5x35 X4 X1 X1 2.5mm 3.0mm X1 X1 LH RH The Cross Frame walk in can be installed on the left or right hand side. The steps below are based on the Right hand.
1. 8FR01 8FR04 8FR05 ST4.0x30 X1 X4 X4 -Put the wall profile 8FR01 against the wall and ensure it is vertical using a spirit level. -Drill the holes(φ6mm)accordingly. -Insert wall plugs 8FR05(4x) into the holes. -Fasten the wall profile on the wall with screws 8FR04(4x).
2. 8FR03 8FR06 8FR07 ST3.5x35 X1 X1 X1 -Insert the cross framed walk in panel 8FR03 into the wall profile. Put the top cover 8FR06 on the wall profile ,and fasten it with screw 8FR07.
3. 8FR02a 8FR02b 8FR02c 8FR02d 8FR02e 8FR02f 8FR05 8FR09 8FR10 2.5mm 3.0mm ST4.0x30 X1 X1 X1 X1 X2 X1 X2 X1 X1 -Put the glass clip 8FR02c on the panel, then fasten the bottom of the clip with inner screws using hex hey 8FR10. -Insert one side of support bar 8FR02a into the the glass clip. -Attach the wall bracket 8FR02d on the other side of support bar, ensure it is level using a spirit level, and mark the position of wall bracket on the wall.
4. 8FR08 -Mount the towel bar 8FR08 onto the glass panel.
5. - Apply silicone sealant to the outside of the enclosure. Please note: Do not apply silicone sealant to the inside of the enclosure. - Do not take a shower within the 24 hours after applying the silicone sealant.
Cleaning and Maintenance: Please do not use abrasive or strong cleaning solution on the shower enclosure, such as alcohol, petroleum liquids or any other chemical cleaner with acidic contents. Should there be any dirty stains on the shower enclosure, please clean it with a soft lint free cloth and warm soapy water. Please rinse it with clean water afterwards.
