Quick Start Guide

IMPORTANT: Please read and comply with all of the instructions provided in this manual before
using the device. Failure to comply with the instructions given in this manual and/or using the
device in ways other than the ones mentioned in this manual may result in serious injury and/or
damage the product.
- Do not use while it is charging.
- Do not drop, knock, or shake the device.
- Do not disassemble as it may cause malfunctions.
- Do not use the device in corrosive liquid or excessive heat environment.
- Keep the device more than 20cm away from the human body during use.
- Long time (more than 3 months) storage: If the device is stored for a long time, the battery's
storage voltage should be 3.6~3.9V and the battery is to be stored in a condition as
Temperature 15~35 ℃, Relative Humidity 45~85% RH, Atmospheric Pressure 86~106 KPa.
Also, it is recommended to charge the battery every six months.
Safety Instruction
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
The End user must follow the specific operating instructions for satisfying RF exposure compliance. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.