User Manual

Phone: [phone] | Fax: [phone] | E-mail: [e-mail]
Address : 1879 Lundy Ave, ste. 138, San Jose, CA 95131
电话：[phone] | 传真：[phone] 转 111 | E-mail: [e-mail]
地址：天津市华苑产业区海泰西路 18 号西 3B-202（300384）
15
5 Regulatory Compliance
This module has been tested and found to comply with the FCC Part15 and IC RSS-210 rules.
These limits are designed to provide reasonable protection against harmful interference in
approved installations. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired
operation.
Modifications or changes to this equipment not expressly approved by Amp’ed RF Technology
may void the user’s authority to operate this equipment.
5.1 Modular Approval, FCC and IC
FCC ID: X3ZBTMOD6
IC: 8828A-MOD6
In accordance with FCC Part 15, the BT24 is listed above as a Limited Modular Transmitter device.
this is a limited modular approval, and any implementation in a host system must be authorized by a
Class II permissive change or a verification by Amp´ed that the same conditions as shown in the original
FCC Filing are met.
5.2 FCC Label Instructions
The outside of final products that contain a BT24 device must display a label referring to the
enclosed module. This exterior label can use wording such as the following:
Contains Transmitter Module
FCC ID: X3ZBTMOD6
IC: 8828A-MOD6
Any similar wording that expresses the same meaning may be used.