Owners manual

www.amp-research.com

1/3

IM75413 rev 04.17.17

BedStep2™ is invented, designed, engineeried and manufactured exclusively by AMP Research and may be covered by one of the following patents:

Three-year limited warranty. Professional installation is recommended.

AMP RESEARCH TECH SUPPORT 1-888-983-2204 (Press 2)

Monday - Friday, 6:00 AM - 5:00 PM PST

Ford Super Duty 2017

F-250/350 (Fits all Beds /Cabs)

APPLICATION

Driver-Side Orientation

Passanger-Side Orientation

Brackets must be configured for Passenger or Driver-Side as shown below:

Torque wrench

13mm

15mm

AMP PART# 75413-01A

21mm

T25 Torx

3/8” Drill Bit

22mm

PAGE 1
AMP PART# 75413-01A APPLICATION Ford Super Duty 2017 F-250/350 (Fits all Beds /Cabs) 8 1 12 5 3 Torque wrench 13 9 3/8” Drill Bit 6 14 10 2 15 4 T25 Torx 7 11 16 17 13mm 15mm 21mm 22mm Brackets must be configured for Passenger or Driver-Side as shown below: Driver-Side Orientation Passanger-Side Orientation 1 AMP RESEARCH TECH SUPPORT 1-888-983-2204 (Press 2) Monday - Friday, 6:00 AM - 5:00 PM PST BedStep2™ is invented, designed, engineeried and manufactured exclusively by AMP Resear
PAGE 2
Assemble brackets as shown in next three steps. Note: Driver side shown. Rotate frame spacer 180° for passenger side. (See image in step 1 for passenger orientation). Torque bolts to 20 ft-lbs. Using a 13mm socket assemble the brackets using (#13) bolts. 2 Do not tighten bolts. Attach Frame spacer to assembled bracket using (#10) bolt and (#17) Washer. Using 15 mm socket, attach bracket to linkage using two (#12) bolts. Snug Sleeve nut (#11) to frame, to allow for adjustment. Do not torque.
PAGE 3
Torque both the Flange nut (#11) and bolt (#10) to 30 Ft Lbs. Install forward support bracket (#5) using supplied M8 hardware (#8) bolts and (#9) nuts. Torque bolts to 16Ft-Lbs. 7 8 21& 22mm 13mm Attach rearward support bracket (#6) using supplied Remove bracket and pre drill hole using a 1/8” drill M8 hardware (#8) Bolts and (#9) Nuts. Locate bracket bit then drill to 3/8”. as shown. Center punch hole using bracket as a guide as shown.
PAGE 4