Owners manual

www.amp-research.com

IM76139 rev 02.01.187/15

AMP RESEARCH POWERSTEP

– DODGE RAM

Front Linkage: On Vehicles that have crash bracket

remove bolts attaching bracket to inner sill of truck.

Thread hex bolts into position as in step 13.

If crash bracket is not present use supplied spacer in

place of bracket. Spacer can be inserted after linkage

is up into position. Spacer will be held in place by

drilling and pop riveting into place. Rivets will be

installed in step 39&40.

With Rivet Nut Tool held in place with 19mm wrench,

tighten Hex Bolt until Rivet Nut deforms and secures

itself to the sheet metal (110 in-Lbs. or 4 turns).

Remove Hex Bolt and Rivet Nut Tool. Repeat for

each of the four mentioned mounting locations.

13mm

19mm

NOTE: Hold Rivet tool with

wrench while loosening bolt.

WARNING: Rivet

Nuts not properly

collapsed will not

hold securely to

sheet metal.

Once rivet nuts are in place use a screwdriver to

push back tab in hole to avoid interference with

linkage mount.

Rear of vehicle

Linkage Installation: On rear linkages thread front

hex bolt into rivet nut with washer. Note on Front

drive linkages both hex bolts can be threaded into

position.

Passenger Side Rear mount position shown.

Rear Linkage: With linkage in position insert Hex

bolts into rivet nut locations. Snug bolts but do not

tighten. Note: Pre threaded bolt will attach to slot

centered on linkage. Idler linkages will use 2 of the

3 mount points.

13mm