Owners manual

www.amp-research.com
8/13
IM77238 rev 02.07.18
AMP RESEARCH POWERSTEP
TM
– Ram Crew Cab
8
Thread supplied bolts 2x (9) into Front Drive Linkage.
Repeat step for Rear Idler Linkage. Do not tighten.
8
14
19
Install provided spacer (22) and M6 bolt (13) into
upper mount as shown on both the Drive and Idler
linkages. Do not tighten.
Slide mounting T-nut into position, Center board in
rail pocket. Tighten fasteners to 10 ft-lbs.
8
14
19
Using a 13mm socket Torque linkage bolts 4x (9)
from step 3 to 16 ft-lbs. Next use a 10mm socket,
torque linkage spacer bolt 2x (13) from step 6 to 8
ft-lbs. Once linkages are tight cycle board to verify
steps deploy under own weight.
13
16
Attach motor to linkage. Using a 4mm hex Torque to
36 in-Lbs.
9
13
22
9
13
14
17
Once linkages are tightened to the bracket tighten
bracket tab Flange bolt (14) and Nut (17). Torque to
16 ft-Lbs.
22
10
1
11
5
13
9
1
12
1
14