Owners manual

www.amp-research.com
9/13
IM77238 rev 02.07.18
AMP RESEARCH POWERSTEP
TM
– Ram Crew Cab
5
18
Insert controller into tie-wrap loops and cinch down
securely. The tie-wraps should cinch down into
channels on controller surface.
7
Prepare large tie-wraps for mounting Power Step
Controller. Loosely loop tie-wraps around large
bundle of wires behind battery in engine
compartment.
26
Remove fuse from Power Step Wire Harness.
6
Connect power leads from Controller, Red to
positive battery terminal and Black to the vehicle
body ground as shown.
6
Locate large rubber wire boot on driver side rewall
as shown below. Slice small opening as shown
below to run trigger wires through.
Tape leading end of wires together and push through
rubber boot to cabin side of the rewall. Silicon
lubricant may be used for ease of passage. The
trigger wires will come out just above and to the left
of the brake pedal.
16
1
17
5
19
15
5
20