Specifications

FIREFINDER NZ CONFIGURATION MANAGER
4.6.4 Adding More Controllers / Adding More Modules
Adding more Controllers, C2, C3, C4, facilitates the addition of more modules which again have to
be set in the Classic or Graphic screens.
Note: SmartTerminal, is only available to Controller 1 (C1) in both protocols and will be shown
to be shaded out, as seen below, to indicate this.
Figure 32: Controller Config C1 Edit Module Types (Graphic Screen)
4.6.5 Edit External LED Mimic.
Click on the “Tab” External LED Mimic and the Edit screen will be displayed.
Description: Click in box and edit the text from the keyboard in the normal way.
Active: Double clicking on the “Y” [Yes] sets the Mimic as active; “N” [No] is inactive.
Double click in the box associated with each LED and the Edit Input selection box will be displayed.
This sets the input that will drive the LED or cause it to change state to indicate a system condition
e.g. Alarm LED normally “off” is turned on if an alarm is initiated. Click on “Change” to set the criteria
In the screen shown an “Assigned Point” has been set to drive the Common LED’s while a “Zone”
has been set for LED’s 1 & 3, a “Group” LED 2, a “LOOP” for LED 4 and a “Panel O/P for LED 5.
Click “Change” to set.
Figure 33: The Edit External LED Mimic Screen