Specifications

FIREFINDER NZ CONFIGURATION MANAGER
4.6.7 Edit Fan Control
Click on the “Tab” Fan Control and the Edit screen will be displayed. Editable fields are:
Master Reset (Enables Master Reset of the Fan Controls)
Latch Reset (
Fitted / Not Fitted (Double click to edit Y = Fitted N = Not fitted)
Description (Double click to enter description)
Termination Card Fitted / Not Fitted (Double click to edit Y = Fitted N = Not fitted)
Fan Set (3 wire, 4 wire or 5 wire systems)
AUX / Latch
Fan Alarm Inputs (Double Click to Edit Fan Alarm Inputs) Note: when the Termination board is fitted
this input will be disabled.
Fan Inhibit Inputs (Double Click to Edit Fan Inhibit Inputs) Note: when the Termination board is fitted
this input will be disabled
Fan Start / Stop Outputs (Double Click to Edit Fan Inhibit Inputs) Note: when the Termination board
is fitted this input will be disabled.
Fan Run / Stop / Fault Indicator Inputs (Double Click to Edit Fan Indicator Inputs) Note: when the
Termination board is fitted this input will be disabled.
Figure 38: 3 Wire Fan Control Screen with and without Termination board fitted
Figure 39: 4 Wire Fan Control Screen & 5 Wire Fan Control