Specifications

FIREFINDER NZ CONFIGURATION MANAGER
1 About This Manual
1.1 Introduction
Configuration Manager:
 Is a software tool designed and written by AMPAC Technologies Pty. Ltd to enable users to
create configuration files for transfer to and from the FireFinder Series II Fire Alarm Control
Panel.
 Is a universal program that meets the required standards of several different countries.
 Has been tested on Windows XP Vista and Win7 operating systems.
Included in the FireFinder Series II configuration is;
 A spreadsheet component for entering the configuration data for the loops / sensors zones
(loop/conventional) and the inputs/outputs either in the panel or on the loops.
 A graphical interface for the entry of function data for input and output control.
 System networking ability.
1.2 General Requirements
The FireFinder Series II FACP has been designed and manufactured from high quality commercial
components so as to comply with major world standards. To ensure these standards are not
compromised in any way installation staff and operators should;
 Be qualified and trained for the task they undertake;
 Be familiar with the contents of this manual prior to the installation, commissioning or
operation of a FireFinder control system;
 Observe anti-static pre-cautions at all times; and
 Be aware that if a problem is encountered or there is any doubt with respect to the
operational parameters of the installation the supplier should be contacted.
1.3 References
ConfigManager
New Zealand Standard:
NZS4512: 2003 - Maintenance of Fire Protection Systems and equipment - Fire Detection and Alarm
Systems.
1.4 Symbols
 Important operational information
Note: Configuration considerations
Observe antistatic precautions