Specifications

FIREFINDER NZ CONFIGURATION MANAGER
Figure 68: Panel, Loop, Group and Global Access screens
7.3.2 Panel, Loop or Group Access
If Global access is not selected then the user has the option to select any combination of Panels,
Loops or Groups. This option allows the user then to determine what parts of the system any node
may display, test, or affect the I/O (cause and effect).
The LCD access may be set to Global, Panel, Loop, or Group access. If the user only wanted
particular information to be displayed then by selecting the Panels Loops or Groups option they
could limit the information displayed. For example if the groups option was selected and group 2 was
entered then only zones or devices with group 2 selected in the Group columns of the data entry
spreadsheet would be displayed. If Loop 1 was entered then all of the devices on loop 1 only would
be accessed, and finally if panels 1 and 2 were entered then only information from panels 1 and 2
would be accessed. The access for the mimic can be defined by either panels, loops or groups.
7.3.3 Mimic Settings
The Mimic Panel settings are configured by double clicking on the Mimic in the project screen. The
Main Information screen will be displayed. It is here that the description, reference and the default
display can be edited. As can be seen below each parameter has been set and the default display
reflects that shown in the Programmable Switches screen. The Programmable Switches screen is
selected by clicking on Tab Programmable Switches. The functions of the two switches can now be
set by using the two drop down menus, as can be seen below Alarm Acknowledge has been
selected for Switch 1 and Reset is about to be selected for Switch 2. Click OK to set.
Figure 69: Screens for Editing the Mimic Settings