Specifications

FIREFINDER NZ CONFIGURATION MANAGER
11 Configuration Programming
There are two methods that may be used to load the software into the FACP. Method 1 uses the
“Transfer “Wizard” window - Method 2 “uses the Terminal window. The more experienced users tend
to use the Terminal window. This requires them to remember commands such as GD etc. For
novices using the transfer wizard means that they do not need to remember these commands.
It is good practice to retrieve the configuration data from the panel before doing any programming.
CONNECT YOUR LAPTOP TO THE FIRE FINDER VIA THE DEBUG/MODEM PORT ON THE
BACK OF THE PANEL USING THE CORRECT CABLE. (Available from AMPAC)
 IMPORANT!!! Retrieve the configuration file from the panel before doing any programming.
This provides an emergency backup. Save any changes to the configuration file as a different file
name.
Figure 81: Report and Backup File Creation Screens
Once a configuration has been created and saved;
Compile the file using or (F5 save created file *.dat). This is the file that is sent to the
FACP.
Connect the PC to the FACP and check communications.