Specifications

FIREFINDER NZ CONFIGURATION MANAGER
11.6 Using a Modem
You can communicate with the FireFinder Series II over a modem using HyperTerminal or any
number of communication packages. Install the modem on your computer as instructed by the
modem manufacturer. In HyperTerminal, under File/Properties, instead of selecting a port (Connect
using), select the modem. Ensure that the phone number to ring is the number for the line connected
to the FireFinder Series II’s modem.
At the FireFinder Series II end you will need to connect CN8 on the 302-674 to a modem. The
connections will be the same as shown in Fig 67.
Starting the HyperTerminal session will ring the modem on the panel, once a connection has been
made all the commands are the same as if making a direct cable connection. Once the connection is
made to the FireFinder Series II, press enter in HyperTerminal and the screen should display:
“Ready” If nothing happens, check your cables.
If the FireFinder Series II is currently running it will be in Application Mode.
Make sure HyperTerminal is set to use the port you have connected the cable to and set up the
configuration as follows
 Bits per second: 19200
 Data bits: 8
 Parity: None
 Stop bits: 1
 Flow Control: None
11.7 Wireless Modem
FireFinder Series II may also be programmed via a wireless modem.