Specifications

FIREFINDER NZ CONFIGURATION MANAGER
NSA
Sending the application software around the network
When you enter the NSA command the “Sending Application” dialogue will appear and the offset will
increase in value until it reaches the Application Size. At this point the “Down Load Complete”
message will appear as well as file received confirmations for each controller and NIC on the
network. It is important that you receive one of these messages from each controller (except the one
that you are programming from) and NIC on the system before proceeding to the next step.
Program the panels around the network using the NPA (Network Program Application) command:
NPA
A short time after entering the NPA command all of the remote Controllers and NIC’s on the network
(except the one that you are programming from) will program and re-start.
As the rest of the panels on the network are in application mode you should now boot the local panel
using the GA (Go Application) command: