User's Manual

AMPAK Technology Inc. www.ampak.com.tw Proprietary & Confidential Information
Doc. NO:
1
1. AP6398XU Evaluation Board Introduction
AP6398XU Evaluation board (EVB) likes as figure1. That is designed for IEEE802.11
a/b/g/n 2x2 WLAN with integrated Bluetooth and FM application. It is subject to provide a
convenient environment for customer’s verification on WiFi or Bluetooth function. There
are many controller pins and reserved GPIO on Evaluation board which describes as
below.
Figure1. Top view of AP6398XU EVB
Interface highlights:
1. U1: AP6398XU SIP module.
2. J1: UART interface connects with UART transport board for BT measuring.
3. J2: Enable(H) or disable(L) Bluetooth and WiFi function.
4. J6: VBAT / WL_VIO / BT_VIO for main system I/O power path.
5. J7: 5V DC mini USB input connector.
6. J8: Standard SDIO interfaces for Wi-Fi performance measured.
7. J11: WL_VIO power path for 1V8 or 3V3 selection.
8. Ct1: WLAN and BT control pins, strongly recommended WL_HWAKE(IRQ)
connected to MCU...
2. WiFi function verification step (Dipole antenna)