® GVT112E & GVT112EW Guitar Speaker Enclosures OWNER’S MANUAL
TABLE OF CONTENTS Important Safety Instructions..................................................2 Introduction / Special Features...............................................3 The Rear Panel......................................................................4 Hookup Diagrams..................................................................5 Block Diagram.......................................................................6 Technical Specifications / Service Information..........................
Introduction Ampeg has a history of delivering pure all-tube tone for over 60 years. During that time we’ve made great friends and damaged some ear drums. We’ve seen it all, lived it all and lived to talk about it. The backbone of American Rock is back. Become a part of the American tone invasion with the all-new Ampeg GVT Series that will set you apart from the rest. Are you ready to experience the taste, smell and tone that is American Rock? Buckle your seat belt, plug in, turn on and turn up.
The Rear Panel MODEL GVT112E_ 16 OHM PARALLEL JACKS MAX POWER INPUT 60 WATTS RMS 1 WARNING! Never turn on or use the amplifier without a load or speaker connected to the amplifier. ALWAYS use a good quality (non-shielded) speaker cable. Never use (shielded) instrument cable. ALWAYS match the amplifier’s speaker output impedance to the impedance of the speaker that is being used. Use only one type impedance output at a time.
Hookup Diagrams MODEL GVT15H POWER CONSUMPTION 62W THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES FOR THE U.S. AND ICES-003, FOR CANADA. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Hookup Diagrams continued... MODEL GVT15H POWER CONSUMPTION 62W THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES FOR THE U.S. AND ICES-003, FOR CANADA. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
TECHNICAL SPECIFICATIONS Max SPL 118 dBSPL @ 1 m Sensitivity 100 dB @ 1 W @ 1 m Impedance 16 Ω Output Power Rating 60 watts rms Speaker Specifications 1 x 12" Vintage 30 Celestion Speaker [GVT112E] 1 x 12" Vintage 30 Celestion Speaker w/legendary Portaflex double baffle design [GVT112EW] Inputs 2 x 1/4" parallel jacks Size (H x W x D) 16.5 in / 420 mm (with feet) x 18.0 in / 457 mm x 11.0 in / 280 mm [GVT112E] 16.5 in / 420 mm (with feet) x 24.0 in / 610 mm x 11.
® & E211TVG WE211TVG serusolcnE rekaepS ratiuG MODEL GVT112E_ 16 OHM PARALLEL JACKS MAX POWER INPUT 60 WATTS RMS LAUNAM S’RENWO
