Owner's Manual

Guitar AmplifierGVT52-112
6
®
™
The Front Panel – Channel 1
The gain, treble, middle, bass and volume
knobs as seen above and mentioned below
[#2–#6]areforchannel1only.Seethe
next page for the channel 2 illustration and
descriptions.
1. INPUT: Connect a guitar to this
1/4"inputusingahigh-quality
shielded instrument cable.
2. GAIN: This control adjusts the
gain of the amplifier.
3. TREBLE: Use this to adjust the high
frequency level of the amplifier. This
provides up to 12 dB of boost or
12 dB of cut at 5 kHz. The high
frequency output is flat at the
center position.
4. MIDDLE: Use this to adjust the middle
frequencies of the amplifier. This
provides up to 10 dB of boost @ 2 kHz
or up to 6 dB of cut at 800 Hz.
1 72 3 4 5 6
5. BASS: Use this to adjust the low
frequency level of the amplifier. This
provides up to 12 dB of boost or
12 dB of cut at 80 Hz. The low
frequency output is flat at the
center position.
6. VOLUME: This control adjusts the
output level.
7. CHANNEL SELECTOR SWITCH: This
switchdeterminesifchannel1[switchto
theleft]orchannel2[switchtotheright]
is in effect.
There are two LEDs above the switch.
The LED on the left will illuminate green
when channel 1 is selected and the LED
on the right will illuminate red when
channel 2 is selected.