Owner's Manual

Guitar AmplifierGVT52-112
8
®
™
The Rear Panel
18. AC POWER INPUT: The amplifier is
equipped with a detachable power cable
that plugs into the IEC Mains socket
on the back of the amplifier. The AC
power cord should only be plugged into
a grounded power outlet that meets all
applicable electrical codes and is
compatible with the voltage, power,
and frequency requirements stated
on the rear panel of the amplifier.
Do not attempt to defeat the safety
ground connection.
19. AC MAINS FUSE: The AC Mains fuse
is used to protect the amplifier from
electrical faults. It is located in the fuse
holder cap and should be left alone
unless a fuse has blown.
If the fuse needs to be replaced,
please refer to the correct fuse
specifications located on the back
panel of the amplifier.
Never bypass the fuse or replace it with
a wrong type or value.
20. CH SELECT/BOOST FOOT SWITCH:
Connect the GVT–FS1 dual foot switch
to this jack for “remote control” of
Channel Selection and Boost On/Off.
Onthestereo1/4"plug,thetipcontrols
Channel Selection and the ring controls
Boost.
NOTE: A foot switch may be purchased at
your local Ampeg dealer or ordered
directly from LOUD Technologies Inc.
Besuretoaskformodel#GVT–FS1.
21. REVERB/EFFECTS LOOP FOOT
SWITCH: Connect the GVT–FS2 dual
foot switch to this jack for “remote
control” of Reverb and Effects On/Off.
Onthestereo1/4"plug,thetipcontrols
Reverb and the ring controls Effects.
When the foot switch is NOT plugged in:
The Reverb is always enabled.
The Effects Loop is active when a cable
isconnectedtotheReturn[22].
When the foot switch IS plugged in:
The Reverb is always affected by the
foot switch operation.
The Effects Loop is controlled by the
foot switch when a cable is connected to
theReturn[22].
The foot switch button for Effects Loop
does nothing when no cable is
connectedtotheReturn[22].
NOTE: A foot switch may be purchased at
your local Ampeg dealer or ordered
directly from LOUD Technologies Inc.
Besuretoaskformodel#GVT–FS2.
22. EFFECTS LOOP RETURN: Use this
1/4"TSunbalancedinputtoreturn
the processed line-level output of
an external effects processor (for
example). The processor could be
fed signals from the Effects Loop
Send[23].
18 20 21 22 23 24 25 2619