Owner’s Guide for the SVT-150H Bass Amplifier Made in the U.S.A.
SVT-150H TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Important Safeguards and Precautions . . . . . . . . . .2 The Front Panel Controls and Their Use . . . . . . .3,4 The Rear Panel . . . . . . . . . . . . . . . . . . . . . . . . . .4,5 Some Suggested Settings . . . . . . . . . . . . . . . . . . .6 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . .
SVT-150H The Front Panel Controls and Their Use 1 2 3 4 5 6 7 1. INPUT: Connect your bass guitar here using a shielded instrument cable. 2. -15dB PAD: If your bass has high-output pickups or active electronics you may notice the Peak LED (#3) flashes or stays on even at low settings of the Gain control (#4). To keep the signal clean, switch in the Pad. This will attenuate the input signal to the preamp allowing you to get the best signal to noise ratio for your bass.
SVT-150H The Front Panel Controls and Their Use 7. ULTRA-MEDIANOS: Este es el control primordial para el rango de las frecuencias medianas. Gire el control del centro hacia la izquierda para lograr un sonido de contorno (más distante, menor salida en el rango mediano) ó del centro hacia la derecha para obtener un sonido realmente penetrante. 10. EQ GRAFICO: Estos controles deslizantes (cursores) le permiten ajustar la salida de las frecuencias que se muestran junto a cada control.
SVT-150H The Rear Panel 22. SALIDA EQUILIBRADA: Esta conexión tipo XLR proporciona una señal de salida equilibrada de preamplificación para conectarse a un tablero mezclador local, una consola grabadora ó amplificadores externos con entradas equilibradas. La señal se puede 16. ENTRADA DE LA LINEA DE CA: establecer como pre ó post-EQ mediante el Conecte firmemente a este receptáculo el 19. ENVIO DE EFECTOS: Conecte la salida interruptor Pre / Post (#20).
SVT-150H Some Suggested Settings ROCK: JAZZ: COUNTRY: FUNK “POPPING:” 6 The setting of the Gain control depends on your particular instrument. The Master should be set to produce the appropriate output volume level. The Graphic EQ can be used to tailor the amplifier to your speaker cabinets, to compensate for room acoustics and to “fine tune” your sound.
SVT-150H Troubleshooting In the unlikely event that you SVT-150H should stop working properly (or just stop working), take a few minutes to troubleshoot it before you call for service. You can save yourself a lot of time and sometimes money by doing it yourself, and often the cure for the problem is something quite simple.
SVT-150H Technical Specifications OUTPUT POWER RATING POWER REQUIREMENTS 150 Watts RMS, 4Ω load, 115VAC Domestic: Export: 115VAC, 60Hz, 140VA 100/115VAC, 50/60Hz, 140VA 230VAC 50,60Hz, 140VA Bass: Ultra-Mid: Treble: ±8dB @ 50Hz +5, -17dB @500HZ +17, -22dB @ 5KHZ TONE CONTROL RANGE GRAPHIC EQ RANGE 40Hz 80Hz 150Hz 300Hz 600Hz 900Hz 2kHz 5kHz 9kHz GAIN SIGNAL TO NOISE RATIO SIZE (W x H x D) AND WEIGHT ±11dB ±8dB ±8dB ±8dB ±8dB ±8dB ±8dB ±9dB ±12dB 66dB typical, tones @ center 75dB typical 19”x9.5”x12.