Owners Owners Guide Guide for for the the Bass Amplifier +12dB +8dB ACTIVE / PEAK 0 0 -12dB -10dB 40Hz -15dB PAD 2kHz 4kHz 10kHz LEVEL ULTRA LO MUTE INPUT 90Hz 180Hz 300Hz 500Hz 1kHz GAIN PEAK / MUTE ULTRA HI BRIGHT GRAPHIC EQ DRIVE BASS MIDRANGE FREQUENCY TREBLE MASTER STANDBY POWER Ampeg ®® is Proudly Made in America
SVT-2 PRO Bass Amplifier TABLE OF CONTENTS Important Safeguards and Precautions . . . . . . . . . . . . . . .2 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 System Block Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . .3 The Front Panel Controls and Their Use . . . . . . . . . . . . . .4 The Rear Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SVT-2 PRO Bass Amplifier An Introduction to your new Ampeg SVT-2 PRO Bass Amplifier The harmonically rich sound and legendary performance of the AMPEG SVT are redefined in the SVT-2 PRO. This dynamically powerful bass amplifier delivers a thundering 300 watts of unsurpassed quality, reliability and tonal flexibility, offering the classic vibrancy of tubes as well as contemporary features. All of the features and controls of your SVT-2 PRO are covered in detail within the pages of this owner’s guide.
SVT-2 PRO Bass Amplifier The Front Panel Controls and Their Use 19 20 +12dB 21 +8dB ACTIVE / PEAK 0 0 -10dB -12dB 40Hz -15dB PAD 1 GAIN 2 3 4 PEAK / MUTE 5 6 1. INPUT: This jack accepts a passive or active instrument or a line level signal through a shielded instrument cable. 2. PAD: This switch attenuates the input signal by 15dB. Attenuation allows the Gain control (4) to be used in a more usable (higher) position.
SVT-2 PRO Bass Amplifier The Rear Panel yyyyyyyyyyyyyyyyyyyyyy @@@@@@@@@@@@@@@@@@@@@@ ÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀ ;;;;;;;;;;;;;;;;;;;;;; @@@@@@@@@@@@@@@@@@@@@@ ÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀ ;;;;;;;;;;;;;;;;;;;;;; yyyyyyyyyyyyyyyyyyyyyy @@@@@@@@@@@@@@@@@@@@@@ ÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀ ;;;;;;;;;;;;;;;;;;;;;; yyyyyyyyyyyyyyyyyyyyyy @@@@@@@@@@@@@@@@@@@@@@ ÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀ ;;;;;;;;;;;;;;;;;;;;;; yyyyyyyyyyyyyyyyyyyyyy @@@@@@@@@@
SVT-2 PRO Bass Amplifier Some Suggested Settings* ROCK: ULTRA LO ULTRA HI IN OUT OUT GAIN PEAK / MUTE OUT GRAPHIC EQ BRIGHT DRIVE BASS MIDRANGE FREQUENCY TREBLE AS NEEDED MASTER AS NEEDED JAZZ: ULTRA LO ULTRA HI IN IN OUT GAIN PEAK / MUTE OUT GRAPHIC EQ BRIGHT DRIVE BASS MIDRANGE FREQUENCY TREBLE AS NEEDED MASTER AS NEEDED COUNTRY: ULTRA LO ULTRA HI OUT OUT IN GAIN PEAK / MUTE OUT GRAPHIC EQ BRIGHT DRIVE BASS MIDRANGE FREQUENCY TREBLE AS NEEDED MASTER AS NE
SVT-2 PRO Bass Amplifier Changing the Tubes Tubes wear out in direct proportion to how often and how hard you play the amplifier. Power tubes should be checked at least once a year – more frequently if you use the amplifier nearly every day. When the power tubes wear out, the amplifier will begin to grow weak, lack punch, fade up and down, or lose highs and lows. Power tubes work together in a push/pull configuration and should all be replaced at the same time with matched or balanced tubes.
SVT-2 PRO Bass Amplifier Technical Specifications OUTPUT POWER RATING TOTAL SYSTEM GAIN TONE CONTROL RANGE Bass: Midrange: Treble: Ultra Low: Ultra High: Bright: GRAPHIC EQ RANGE GRAPHIC EQ LEVEL SIGNAL TO NOISE RATIO TUBE COMPLEMENT POWER REQUIREMENTS Domestic: Export: SIZE AND WEIGHT 300 Watts RMS minimum continuous @ <3% THD into 2 or 4 ohms, 0.4VRMS input 76dB, @1kHz w/levels up, tones flat; -3dB @30Hz, 15kHz ±12dB @ 40Hz +12dB, -15dB @ Frequency selected (220, 450, 800, 1.
