Operation Manual

SVT-3 PRO Bass Guitar Amplifier
8
28
CAUTION:
TO
REDUCE THE RISK
OF FIRE, REPLACE
FUSE WITH SAME
TYPE AND RATING.
SPEAKER OUTPUTS
AC LINE IN
ATTENTION:
UTILISER UN FUS-
IBLE DE RECHANGE
DE MEME TYPE.
110/115V: 250V T10A SLO BLO
230V: 250V T5A SLO BLO
MODEL:
SERIAL:
LINE: V ~ Hz
WATTS: MAX
SVT-3PRO
120 XX
1000
CAUTION
RISK OF ELECTRIC
SHOCK - DO NOT OPEN
RISQUE DE CHOC
ELECTRIQUE
NE PAS OUVRIR
TO REDUCE THE RISK
OF FIRE OR ELECTRIC
SHOCK, DO N OT EX-
POSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
AVIS:
275 WATTS @ 8 OHMS
450 WATTS @ 4 OHMS
4 OHM MIN. LOAD
EFFECTS LOOP
TUO RENUTLEVEL
RETURN SENDPOWER AMP
IN
PREAMP
OUT
FOOTSWITCH
PRE
PULL
GROUND
LIFT
POST
29 30 31 32 33 34 35
3222 2726252421
BALANCED
TRANSFORMER BAL. LINE OUTPUT
BALANCED/
UNBALANCED
21. SPEAKON
®
JACK: Use of this heavy-
duty connector is recommended when
playing at full output levels due to
its incredibly high current handling
capability. Connect the amplifier to
the speaker cabinet(s) using heavy
gauge speaker cables terminated
with the appropriate connectors.
The pin connections for this jack are:
1+ = positive
1– = negative
22. RACK SUPPORT FASTENER: For
the most secure rack installation, it is
recommended that a supplemental sup-
port be fabricated and fastened to the
amplifier via this threaded insert. Use a
1/4–20 threaded bolt that will not pro-
trude more than 1/2" into the amplifier
to connect the strap.
23. LINE OUTPUT LEVEL / GROUND
LIFT: This control adjusts the output
level at both line output jacks. This
control works independently from the
front panel master control. If necessary,
pull this knob to engage the ground lift
and eliminate hum.
24. POST-EQ / PRE-EQ: The signal at
the line out jacks can be set to either
Pre-EQ or Post-EQ with this switch.
With the switch in the OUT position,
the signal at the jacks is Pre-EQ. This
is a direct output not affected by any
EQ or boost settings. With the switch
in the IN position, the signal is
Post-EQ and is controlled and
modified by the tone controls,
Graphic EQ and the effects loop.
25, 26. TRANSFORMER BALANCED
LINE OUTPUTS: These jacks supply
a balanced/unbalanced preamp output
signal for connecting to a house mixing
board, recording console or external
amplifiers with balanced inputs. The
signal can either be set to Pre- or Post-
EQ with the selector switch and its level
is controlled by the line out level control.
27. TUNER OUT: This jack supplies the
only live output when the mute switch
is engaged. This allows for silent tuning
through an electronic tuner or killing the
house send with a monitor mixer send
still active.
28. FUSE: The fuse protects the unit from
damage due to overload conditions or
AC power line surges. If the fuse blows,
replace it only with the same size and
type.
(Speakon
®
is a registered trademark of Neutrik AG.)
The Rear Panel