Bass Amplifier Owner's Manual

ManualsBrandsAmpeg ManualsMusical Instrument AmplifierSVT-350H

Owner’s Guide

for the

SVT-350H

Bass Amplifier

Made in the U.S.A. by

Summary of content (8 pages)

PAGE 1
Owner’s Guide for the SVT-350H Bass Amplifier Made in the U.S.A.
PAGE 2
SVT-350H TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Important Safeguards and Precautions . . . . . . . . . .3 The Front Panel Controls and Their Use . . . . . . . .4 The Rear Panel . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Some Suggested Settings . . . . . . . . . . . . . . . . . . .6 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
SVT-350H Important Safeguards and Precautions All Ampeg products are designed for continuous, safe operation, as long as common sense is used and steps are taken to help avoid certain problems. Abiding by the following rules can help prevent damage to your amplifier, yourself and others. • The amplifier is equipped with a three-pronged AC power cord. To reduce the risk of electrical shock, NEVER remove or otherwise attempt to defeat the ground pin of the power cord.
PAGE 4
SVT-350H The Front Panel Controls and Their Use +12dB 4 5 6 3 Pad Peak 1 2 3 5 6 3 9 0 10 4 7 82 1 0dB 4 7 2 5 6 3 1 9 0 10 4 7 82 5 1 9 0 10 4 7 5 6 3 7 82 1 9 0 10 0 8 1 9 0 12dB –12dB 10 Limit Gain Bass Ultra Mid Treble Master 4 5 6 7 8 1. 0dB (INPUT): The signal output from an instrument (active or passive) or a line level signal may be connected here by means of a shielded instrument cable. 2.
PAGE 5
SVT-350H The Rear Panel MODEL SVT-350H SPEAKERS SERIAL # 115VAC, 60Hz T10A SLO BLO 100/115VAC, 50Hz: T8A SLO BLO 230VAC, 50Hz: T4A SLO BLO EFFECTS LOOP -20dB 0dB AC LINE IN 200W @ 8 OHMS 350W @ 4 OHMS 4 OHMS MINIMUM 14 15 16 14. FAN: The temperature controlled, variable speed fan forces cool air into the amplifier, forcing heat out through the exhaust vents (also on the rear panel, between the speaker jacks and the power amp in jack). Never block the vent holes or the fan openings.
PAGE 6
SVT-350H Some Suggested Settings The setting of the Gain control depends on your particular instrument. The Master should be set to produce the appropriate output volume level. The Graphic EQ can be used to tailor the amplifier to your speaker cabinets, to compensate for room acoustics and to “fine tune” your sound.
PAGE 7
SVT-350H Troubleshooting In the unlikely event that your SVT-350H should stop working properly (or just stop working), take a few minutes to troubleshoot it before you call for service. You can save yourself a lot of time and sometimes money by doing it yourself, and often the cure for the problem is something quite simple.
PAGE 8
SVT-350H Technical Specifications OUTPUT POWER RATING 350 Watts RMS, 4 ohm load, 120VAC 200 Watts RMS, 8 ohm load, 120VAC POWER REQUIREMENTS Domestic: Export: 115VAC, 60Hz, 205VA 100/115VAC, 50/60Hz, 205VA 230VAC, 50/60Hz, 205VA TONE CONTROL RANGE Bass: Ultra Mid: Treble: ±8dB @ 50Hz ±8dB @ 500Hz +12dB/-19dB @ 5kHz GRAPHIC EQ RANGE 40Hz: ±11dB 80Hz: ±8dB 150Hz: ±8dB 300Hz: ±8dB 600Hz: ±8dB 900Hz: ±8dB 2kHz: ±8dB 5kHz: ±9dB 9kHz: ±12dB GAIN 45dB typical, tones @ center SIGNAL TO NO