Owners Guide for the Bass Preamp INPUT PAD / MUTE GAIN ULTRA LO / BRIGHT DRIVE BASS MIDRANGE FREQUENCY TREBLE ULTRA HI / GRAPHIC EQ GRAPHIC EQ +12dB 40 90 180 300 50 1k MASTER 2k 4k 10k POWER +8dB ACTIVE / PEAK -15dB MUTE PEAK / MUTE LO HI BRT EQ 0 -12dB LEVEL -10dB ON Ampeg ®® is Proudly Made in America
SVP-PRO Bass Preamp TABLE OF CONTENTS Important Safeguards and Precautions . . . . . . . . . . . . . . .2 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 The Front Panel Controls and Their Use . . . . . . . . . . . . . .4 The Rear Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Some Suggested Settings . . . . . . . . . . . . . . . . . . . . . . . . .
SVP-PRO Bass Preamp An Introduction to your new Ampeg SVP-PRO Bass Preamp The harmonically rich sound and legendary performance of the AMPEG SVT are redefined in the SVP-PRO. This dynamic preamp delivers unsurpassed quality, reliability and tonal flexibility and offers the classic vibrancy of tubes. The SVP-PRO is the preamp section of our muchrespected SVT-2 PRO. All of the features and controls of your SVP-PRO are covered in detail in this owner’s guide.
SVP-PRO Bass Preamp The Front Panel Controls and Their Use INPUT PAD / MUTE ULTRA LO / BRIGHT GAIN DRIVE BASS MIDRANGE FREQUENCY TREBLE ULTRA HI / GRAPHIC EQ GRAPHIC EQ +12dB 40 90 180 300 50 1k MASTER 2k 4k 10k POWER +8dB ACTIVE / PEAK -15dB MUTE 1 2 3 PEAK / MUTE 4 5 LO HI BRT EQ 6 7 8 9 1. INPUT: The signal output from an instrument (active or passive) or a line level signal may be connected to this jack by means of a shielded instrument cable. 2.
SVP-PRO Bass Preamp The Rear Panel FOOT SWITCH PREAMP OUT EFFECTS TUNER OUT TRANSFORMER BAL. OUT PRE MADE IN THE U.S.A. BY SLM ELECTRONICS 1400 FERGUSON AVENUE ST. LOUIS, MO 63133 AC LINE IN 21 115V 230V 22 21. AC LINE IN: Firmly insert the supplied AC power cord into this socket until it is fully seated. Plug the male end of the cord into a grounded AC outlet. DO NOT DEFEAT THE GROUND PRONG OF THE AC PLUG! 22.
SVP-PRO Bass Preamp Some Suggested Settings* JAZZ: GAIN ULTRA LO / BRIGHT PEAK / MUTE DRIVE BASS MIDRANGE FREQUENCY TREBLE ULTRA HI / GRAPHIC EQ IN OUT LO HI OUT OUT BRT EQ ADJUST UNTIL PEAK LED FLASHES FUNK: GAIN ULTRA LO / BRIGHT DRIVE BASS MIDRANGE FREQUENCY TREBLE IN IN OUT OUT BRT EQ LO PEAK / MUTE ULTRA HI / GRAPHIC EQ HI ADJUST UNTIL PEAK LED FLASHES ROCK: GAIN ULTRA LO / BRIGHT PEAK / MUTE DRIVE BASS MIDRANGE FREQUENCY TREBLE ULTRA HI / GRAPHIC EQ OUT O
SVP-PRO Bass Preamp Changing the Tubes The performance characteristics of tubes are degraded in direct proportion to how often and under what conditions the amplifier is used. Preamp tubes typically last longer than power tubes. When a preamp tube wears out, the preamp may squeal, get noisy, lose gain and sensitivity, or just quit working. A service center can determine which tube(s) may need replacing. To gain access to the tubes in the SVP-PRO, the top must be removed.
SVP-PRO Bass Preamp Technical Specifications TOTAL SYSTEM GAIN TONE CONTROL RANGE Bass: Midrange: Treble: Ultra Low: Ultra High: Bright: GRAPHIC EQ RANGE GRAPHIC EQ LEVEL SIGNAL TO NOISE RATIO TUBE COMPLEMENT POWER REQUIREMENTS Domestic: Export: SIZE AND WEIGHT 76dB, @1kHz w/levels up, tones flat; -3dB @30Hz, 15kHz ±12dB @ 40Hz +12dB, -15dB @ Frequency selected (220, 450, 800, 1.
