Owner`s manual

SVT-VR Bass Guitar Amplifier
8
28. IMPEDANCE SELECTOR: Use this
switch to match the output impedance
of the amp to the speaker(s) being used
(2 or 4 ohms). For help in deciding the
total impedance of your system, consult
the chart below.
17 19 20 21 22 23 2426 282725 2918
29. SPEAKER OUTPUTS: Two 1/4" output
jacks and one Speakon
®
output jack
supply speaker-level power to the
cabinet. The rated power output is 300
watts rms into 2 or 4 ohms.
The two identical outputs are wired in
parallel, and you can use either one, or
use both. Make sure the total speaker
impedance load is 2 ohms or greater.
Use speaker cables with Speakon or
1/4" TS ends to make the connections.
Do not use instrument cables as they
may overheat.
NOTE: In some areas, 1/4" speaker jacks
are not appropriate for use on amplifiers
with high output power levels. For this
reason, use the Speakon jack instead.
The Rear Panel continued
(Speakon
®
is a registered trademark of Neutrik AG.)
Cabinet Number of Total
Impedance Cabinets Impedance
2 ohms 1 2 ohms
4 ohms 1 4 ohms
4 ohms 2 2 ohms
8 ohms 2 4 ohms
8 ohms 4 2 ohms