Owner’s Guide for the V-50H Guitar Amplifier Made in the U.S.A.
V-50H Guitar Amplifier Thank you for choosing Ampeg. In order to obtain the best performance from your new amplifier we recommend you review the information in this owner’s guide prior to its use. 1 2 3 4 5 6 7 8 9 THE FRONT PANEL: 1. Power switch is used to turn the amplifier on and off. 4. Bass adjusts the output level of the low frequencies and offers a cut or boost of 24dB at 50Hz. will be clean. As you push the volume higher and crank your guitar the sound becomes distorted. 2.
The V-50H is covered with a durable Tolex material: wipe it clean with a lint-free cloth. Never spray cleaning agents onto the cabinet. Avoid abrasive cleansers which would damage the finish. El V-50H esta cubierto con un material durable Tolex: limpielo con una toalla seca. Nunca rocie el gabinete con sustancias limpiadoras. Evite usar materiales abrasivos con los cuales pueda danar el acabado. Le V-50H est couvert avec «Tolex» un revêtement noir et durable.
V-50H TECHNICAL SPECIFICATIONS: OUTPUT POWER RATING 50 Watts RMS @ 5 % THD 8 ohm load 120 VAC SIGNAL TO NOISE RATIO 70dB Typical POWER REQUIREMENTS 120 VAC, 60Hz, 110VA 100/115 VAC, 50/60Hz, 110VA 230 VAC, 50/60Hz, 110VA GAIN 69dB TREBLE 12dB Boost and Cut @ 6kHz MID 16dB Boost and Cut @ 800Hz BASS 24dB Boost and Cut @ 50Hz SIZE AND WEIGHT 29.5” W x 11.5” H x 9” D 34 lbs. Ampeg continually develops new products, as well as improves existing ones.
