User Manual

To move around the menu, use the regulator or briefly
press the mode control button. (5 and 4 in Figure 5.1).
To select a menu item,
press the regulator or press
and hold the mode control
button.
figure 5.7
Configure
Lang: ENG
Device info
Exit
Wi-Fi connection settings
When connected to a Wi-Fi network, the PSU must be
connected to a charger. (For details on the configuration
mode, see section 5.6.)
You do not need to enter
a WI-FI password when
connecting.
Open the browser of your device (PC, phone, tablet,
etc.) and either follow the link http://192.168.0.1 or enter
the IP address of the power supply unit in the browser
address bar (by default this is 192.168.0.1).
In the configuration mode, the PSU creates its Wi-Fi
access point. You can see its SSID and IP address of
the power supply unit by going to the «Settings» section
(Figure 5.7).
To connect the power supply unit to your WI-FI network,
follow these steps:
Find the network generated by the power supply unit
(Figure 5.8) in the list of WI-FI networks on your device
(PC, phone, tablet, etc.) and connect to it the way you
connect to an ordinary WI-FI network.
WiFi info:
PS_0004e3dd
192.168.0.1
figure 5.8
In the window that opens,
enter the name of YOUR
WI-FI network in the «SSID»
field, YOUR WI-FI network
password in the «Password»
field, and click the «Save»
button (Figure. 5.9).
After a successful connection
to your WI-FI network, you
will see a message asking
you to restart the power
supply unit.
figure 5.9
ATTENTION. Only WPA2 networks are supported.
19
5.SETTING UP AND USING THE POWER SUPPLY UNIT