User Manual

This allows you to independently develop a variety

of sensors using Arduino and similar platforms and to

conduct experiments with them in other areas of physics,

biology, chemistry, etc.

6.5 Setting up the multimeter

In order to access the settings menu, press and hold the

mode control button (3 in Figure 6.1) for 3 seconds.

In the settings mode you can find the options of turning

on Wi-Fi and the current network connection status. The

procedure for setting up the multimeter is similar to the

procedure for setting up the power supply unit. (see

section 5.5)

6.6 Configuration

Considering the operating conditions of the PSU, you can

change settings related to Wi-Fi access point and device

language only when it is connected to the charger - only

during charging.

In order to enter the configuration mode, connect the

device to the charger, turn it on with the power button

(4 in Figure 6.1), then press the mode control button

(3 in Figure 6.1) and hold it for 3 seconds.

In other cases, the configuration of the multimeter is

similar to the configuration of the power supply unit.

(see section 5.6).

6.7 Working with the device on the Internet

When the multimeter is connected to a Wi-Fi access

point, all other devices which are connected to the

same access point — computers, tablets, smartphones,

etc. - can be used to obtain the results and conduct

automated experiments.

You can find out the IP address of the device in the

configuration mode, by selecting Wi-Fi info from the

menu. The device also displays it on the screen after a

successful connection.

6.SETTING UP AND USING THE MULTIMETER