User Guide

Ampex 1308904-X4 Preliminary Draft A-23
ACL Application Programmer’s Guide CHS Failure, Error, and Warning Codes
WARNING MESSAGES (2XX, 4XX)
2001d (7D1h) +24Vdc supply is indicating greater than 26 volts
2002d (7D2h) +24Vdc supply is indicating less than 22 volts
2003d (7D3h) +5Vdc supply is indicating greater than 5.5 volts
2004d (7D4h) +5Vdc supply is indicating less than 4.5 volts
2005d (7D5h) -15Vdc supply is indicating greater than 16 volts
2006d (7D6h) -15Vdc supply is indicating less than 14 volts
2007d (7D7h) Drive elevator roller mda integrated circuit [U4] is over temperature
2008d (7D8h) Elevator calibration data is cleared, recalibrate
2009d (7D9h) Elevator calibration data is out of range
2010d (7DAh) Elevator calibration data read checksum error
2011d (7DBh) Elevator failed to slow down for middle vane
2012d (7DCh) Elevator is already parked
2013d (7DDh) Elevator mda integrated circuit #1 [U20] is over temperature
2014d (7DEh) Elevator mda integrated circuit #2 [U9] is over temperature
2015d (7DFh) In-arm calibration data is cleared, recalibrate
2016d (7E0h) In-arm calibration data is out of range
2017d (7E1h) In-arm calibration data read checksum error
2018d (7E2h) Loader frame is not positioned to rack
2019d (7E3h) Loader port roller mda integrated circuit [U3] is over temperature
2020d (7E4h) Middle vane sensor positioned too high
2021d (7E5h) Middle vane sensor positioned too low
2022d (7E6h) No available elevator bin for the cartridge in drive
2023d (7E7h) Out-arm calibration data is cleared, recalibrate
2024d (7E8h) Out-arm calibration data is out of range
2025d (7E9h) Out-arm calibration data read checksum error
2026d (7EAh) Tape Drive +5 Vdc power is missing
Table A-5. CHS Failure, Error, and Warning Codes (Continued)
CHS Code Description