Brochure

Amphenol 25
C 16-3
Technical Information
1000
500
400
300
200
100
50
40
30
20
10
5
0,05 0,1 0,2
0,5 1,0 1,5 2,5 4,0 6,0 10,0
N
4000
3000
2000
1000
500
400
300
200
100
50
40
30
20
lb
28
26
24
22
20
18
16
14
12
10
8
AWG
mm
2
Min. tensile strength N / lb
Wire gauge in mm
2
/ AWG
• Crimp connection
A crimp connection is a non-detachable electrical connection between a
wire and a crimp contact produced with the crimp technology.
Precise crimping dies which are matched to the crimp barrel and the
wire size and a defined deformation result in a reliable electrical
connection.
There are open crimp barrels (stamped contacts) and closed crimp
barrels (turned contacts).
The main advantages of crimp connections are:
• Efficient termination of contacts.
• Reproducible termination achieve consistent electrical
and mechanical results
The requirements for crimp connections are defined
in DIN
EN 60352-2, IEC 60352-2 .
Diagram 2
An important point of the quality of a crimp connection is the achieved
tensile strength of the termination.
Easily measured, the tensile strength is a practible means for quality
control purposes.
Diagram 2 below shows the required minimum tensile strength for open
and closed barrels depending on the wire size.
Assembly instructions
For crimp contacts use the released crimp tool.
The insertion and extraction of crimp contacts shall only be approved with
the corresponding insertion / extraction tool.
A detailed description of the crimp technology can be found in
our crimp tooling
catalogues .
Crimp contacts are in this
catalogues on page 21 and 22.