Datasheet

15
eco | mate
m
Derating-Curves
2)
Prüfstelle Kennwert
6 + PE
UL
*
3+PE, 600 V, 13 A at AWG 16
3+PE, 600 V, 5 A at AWG 26
6+PE, 600 V, 13 A at AWG 16
6+PE, 600 V, 5 A at AWG 26
CSA 3+PE, 600 V, 10.5 A at AWG 16
6+PE, 600 V, 10.5 A at AWG 16
In general approvals refer to versions of the connector series. Test report
upon request.
* Please refer to „conditions of acceptability“
eco | mate
m
High Voltage | Technical Data
1)
DIN EN 60664-1
^
=
VDE 0110-1
^
=
IEC 60664-1
2)
All contacts under load
General Characteristics Standard Characteristics
Number of contacts 3 + PE 6 + PE
Termination technique crimp type
Wire gauge / AWG 0.14 - 1.5 mm
2
AWG 26 - 16
Flammability UL 94 VO
Locking system round thread
View on termination side
of male contact insert
Electrical Characteristics
Rated voltage IEC 60664-1
1)
600 V
Pollution degree IEC 60664-1
1)
3 (mated)
Installation (overvoltage) category IEC 60664-1
1)
III
Material group IEC 60664-1
1)
II
Rated impulse withstand voltage IEC 60664-1
1)
6000 V
Current carrying capacity IEC 60512-5-2 14 A / + 40°C
Contact resistance IEC 60512-2-1 ≤ 5 m Ω
Insulation resistance IEC 60512-3-1 ≥ 10
8
Ω
Climatic Characteristics
Climatic category IEC 60068-1 40 / 125 / 56
Operating temperature -40°C ... +125°C
Mechanical Characteristics
Degree of protection IEC 60529 IP 65
Insertion and withdrawal force IEC 60512-13-2 ≤ 35 N
Mechanical operation IEC 60512-9-1 ≥ 500 mating cycles
Materials
Housing material PA 6.6 / PA 6
Dielectric material PA 6.6 / PA 6
Gasket material Neopren
Contact plating silver plating / gold plating
Umgebungstemperatur (°C)
0 20 40 60 80 100 120 140
30
25
20
15
10
5
0
Strombelastbarkeit
a
Curve Wire gauge
a 1.5 mm
2
stamped
crimp contacts
Remark
The stated technical values refer to the use as connector without breaking capacity (COC). If these components are used as plug and socket
device a reduced current carrying capacity has to be considered.
The characteristics have to be requested from the manufacturer.
Current carrying capacity
Ambient temperature