Datasheet

C 16-1
Characteristics
10 Amphenol
Characteristics
3 + PE 6 + PE
solder typescrew type crimp type
400 V 250 V 200 V
33
III III
II II
1680 V 1950 V
16 A / + 55 °C 10 A / + 55 °C 13 A / + 55 °C
³ 10
8
½³10
8
½
² 5 m ½²5 m ½
40 / 125 / 5640 / 100 / 56
IP 67
³ 500 mating cycles
Polyamid 6.6
Polyamid 6.6
silver plated (gold plated upon request)
screw type solder
0,75 / 18
crimp
0,14 -1,5 / 26 - 16max. 2,5 / 14
Neoprene
UL 94 VO
round thread DIN 405
² 15 N
² 30 N
Number of contacts
Electrical Characteristics
Rated insulation voltage
Pollution degree
Installation (overvoltage) category
Material group
Test voltage
Current carrying capacity
Insulation resistance
Contact resistance
IEC 60664-1
IEC 60664-1
IEC 60664-1
IEC 60664-1
6000 V 4000 V
Rated impulse withstand voltage IEC 60664-1
IEC 60664-1
IEC 60512-3, Test 5b
IEC 60512-2, Test 3a
IEC 60512-2, Test 2a
Climatical Characteristics
Climatic category
-40°C ... +100°C / -40°F ... +212°F
Operating temperature
IEC 6068-1
Mechanical Characteristics
IP-degree of protection IEC 60529
Insertion and withdrawal force IEC 60512-7, Test 13b
IEC 60512-5, Test 9aMechanical operation
Materials
Housing material
Dielectric material
Gasket material
Contact plating
Other Characteristics
Termination technique
Wire gauge mm
2
/AWG
Flammability
Locking system
General Characteristics Standard
2450 V
The stated technical values refer to the use as connector.
If these components are used as plug and socket device a reduced current carrying capacity has to be considered.