Amphenol 15 Amp H4 Fuse Specifications

Amphenol Industrial Global Operations (AIGO) offers products and solutions
for all segments of the solar electric system. AIGO understands the need for
efficient (low loss) power transfer, highly reliable, and cost effective solutions
that are required to be competitive in this industry. We can provide panel
manufacturers, installers, and OEM's with connectivity products for both thin
film and crystalline silicon technologies.
AIGO’s molded in-line fuse, HelioFuse, provides a quick replaceable solution
for installing in-line solar fuses. The molded construction provides weather
tight housing preventing moisture from getting to the fuse construction. The
in-line fuse provides the needed electrical protection to prevent damage to
the solar array should a ground fault occur. The connectorized fuse
construction allows for rapid removal and replacement upon correction of a
ground fault.
HelioFuse is offered in two configurations; A connector version which plugs
right into an industry standard solar connector (Helios H4 Connector) and our
wire overmold version for custom harnesses.
Amphenol Industrial Global Operations can help you power the planet with
the sun. The HelioFuse is just one of the solar solutions Amphenol Industrial
Global Operations has to offer.
HelioFuse
Amphenol
www.amphenol-industrial.com
Features:
• Rugged, low cost solution
• Patent-pending design
• Fully intermateable with industry
standard connectors
• 1A to 20A current rating
• 600V and 1000V versions
• 10,000A withstand rating
• IP68 protection degree
• Meets UL 94 V-0 flammability rating
• UL approved
®
IDS-53-3
www.tpil.com
Assembly Instructions:
• Always follow the manufacturer’s recommended
installation instructions for the connectors used in the
assemblies that are specified by the system designer.
• If Amphenol H4 has been specified, please find
the Amphenol H4 Assembly Instructions here:
• Always follow PPE protocol when handling these
assemblies under source load. Please ensure
necessary PPE actions are employed before handling
any of the components used in these assemblies
(including but not limited to overmolds, connectors,
wire) while under source load.
www.amphenol-industrial.com/index.php/literature/catalogs