User Manual

User and Installation GuideUser and Installation Guide
Page 7 Page 12
Pairing the transmitter and wireless devices
In order for the transmitter to transmit to wireless devices (audio receivers,
wireless speakers etc.), they need to be paired. To pair the transmitter and
a wireless device, push the transmitter pairing button. The network status
light will start flashing quickly.
Then push the pairing button of the wireless device within 5 minutes.
You can transmit to up to 4 wireless devices from one transmitter. Pair
each wireless device as shown above.
Description of the network status light
Flashing Slowly: No paired wireless device detected
Flashing Quickly: Pairing Mode
Always On: Audio is being streamed
Placing the transmitter
Ideally, the transmitter should be placed at an elevation such that there
are no obstacles between the transmitter and wireless receivers or
amplifiers (line of sight) in an area where there will be the least amount
of traffic. We suggest that you place the transmitter on top of your audio
source.
READ THESE SAFETY INSTRUCTIONS CAREFULLY AND
HEED ALL WARNINGS IN THIS MANUAL.
POWER SOURCE
To product malfunction, and to protect against electric shock, fire or
personal injury, please observe the following:
• This product has been designed to work with 120-volt AC current using
the supplied AC adapters. Connection to a line voltage other than that or
use of non-compatible AC adapters may create a safety and fire hazard
and may damage the product.
• Do not run power cords under rugs or carpets or place heavy objects on
them.
• Damaged or deformed power cords are hazardous and should be
replaced immediately by a qualified service technician.
LOCATION
• Do not use this product outdoors or in cars.
• Do not place this product in direct sunlight, or near heat sources.
• Keep this product away from strong magnetic objects.
VOLUME CONTROL
• Do not turn up the volume of the wireless amplifiers which are paired with
the transmitter while listening to a portion with very low level input or no
audio signal to avoid damage to your speakers during a peak level.
• Turn the amplifier volume control to minimum prior to connecting or
disconnecting the transmitter or amplifier and prior to switching audio
sources as this may cause loud clicks which can damage your speakers.
CARE
• Do not place any object containing water or other liquids on this product.
• Do not remove the cabinet. Touching parts inside the cabinet could result
in electric shock and damage to the product.
NON-USE PERIODS
• When the product is not being used for a long period of time, unplug the
product.
IMPORTANT SAFETY INFORMATION
ATTENTION!