User's Manual
Table Of Contents
- Warnings and general precautions for safety
- Regulatory and safety notices
- Product description and intended use
- Remove the front cover
- Prepare for bead chain size #10, 4.5mm
- Prepare support wall for cord loop and small size bead chains
- Prepare for cord loop D30, K35, C30, 2.7-3.5mm
- Prepare for vertical blinds track cord, bead chain size #6 and size #8
- Mount device to wall
- Charing the battery
- Set limits
- Set favorite position
- Set speed
- Set energy mode
- Pair with Android or iOS app
- Remove pairing
- Reboot the device
- Factory reset
- Technical specifications
2021-v1-en, main user manual MOVE motor Pro
16
Mount device to wall
Warning! - Before starting, carefully read the warnings in the first part of this user manual. It is important that you install
MOVE device as described in this manual to ensure safe use of the motor.
Note! The motor inside a MOVE device has a torque of about 1Nm and incorrect installation and/or usage can be dangerous.
Check the condition of the MOVE device upon unboxing it, do not install if damaged. Check if the MOVE device is compatible
with the product you intend to install it on before installing, do not install if it is not compatible.
Make sure the product you intend to install the MOVE device on is working correct and do not have any defects, do not install if
it is not working correct or if it has any defects.
Make sure that the cord or bead chain of the product you intend to install the MOVE device on is compatible with any of the
pulleys included in the package, do not install if it is not compatible.
Before installing a MOVE device make sure that there is enough free space in the window for the MOVE device to operate freely,
do not install if there is a possibility that things can get caught and tangled in by the motor motion or the window cover
movement.
Prepare the MOVE device depending upon what window cover it should be installed at. Follow the guides in this user manual for
selecting the correct pulley and if needed support wall.
Remove the front cover of the device in the way described in page 7 (Remove the front cover) in this user manual.
Use screws and anchors that are appropriate to the type of wall where MOVE is installed at. The supplied screw and anchor do
not work at all types of walls and need to be replaced at some types of walls. Consult a professional for what type of screws and
anchors to use if uncertain.
Important! Make sure the cord or bead chain is sufficiently stretched when doing the installation. It should not be too
stretched and not too little stretched, the amount of starch needed is different between different type of window covers
and the slot holes at the MOVE device are intended to enable fine tuning of the stretch. If the stretch is wrong the MOVE
device may not keep the open and closed limits due to slippage of cords or skipping of beads at bead chains.
At each side on the of MOVE
device there are slot holes
(marked 5 and 6 in the
“Inside device overview”
picture at page 8) that should
be used when installing MOVE
devices.
The slot holes are behind the
front cover.
Use either the included screw
and anchor (marked 8 in the
“All included parts” picture
at page 5) or replace them
with screws and anchors that
are appropriate for the wall
where installation should be
made.