User's Manual
Table Of Contents
- Warnings and general precautions for safety
- Regulatory and safety notices
- Product description and intended use
- Remove the front cover
- Prepare for bead chain size #10, 4.5mm
- Prepare support wall for cord loop and small size bead chains
- Prepare for cord loop D30, K35, C30, 2.7-3.5mm
- Prepare for vertical blinds track cord, bead chain size #6 and size #8
- Mount device to wall
- Charing the battery
- Set limits
- Set favorite position
- Set speed
- Set energy mode
- Pair with Android or iOS app
- Remove pairing
- Reboot the device
- Factory reset
- Technical specifications
2021-v1-en, main user manual MOVE motor Pro
20
Reboot the device
MOVE devices can be rebooted by selecting this option the settings menu.
Do this to reboot:
1. Wake the device by clicking anywhere in the display
2. Click the settings icon in the top right corner of the display
3. Click the “More settings” option
4. Click the “Reboot” option. The device will do the reboot and then load the main view
Factory reset
To clear all settings and go back to the default state of a MOVE device, a factory reset can be performed.
To perform a factory reset do this:
1. Wake the device by clicking anywhere in the display
2. Click the settings icon in the top right corner of the display
3. Click the “More settings” option
4. Click the “Factory reset” option
5. Confirm by clicking “Yes” option. The device will do the factory reset and then load the main view
Technical specifications
Power source: Battery LiPo pack 7.4V 2600mAh
Radio protocol: Bluetooth 5.0
Motor torque: ≈1Nm (lift/pull capacity: 10kg/22lb)
Reel mechanism: Different types of pulleys
Device dimensions: Length 162mm, with 55mm, height 35mm
Weight: 425g
Battery details
Important! Only use the supplied battery or a battery supplied by the MOVE device manufacturer. Other batteries are not
allowed to be used with the MOVE device.
Important! Incorrect installed battery is dangerous.
The battery is behind the front cover under the device circuit board. The battery connector is snapped in place by pressing
down on top of it and snapped off by gently pulling the battery cable straight up/away from the MOVE device.