User's Manual
Table Of Contents
- Warnings and general precautions for safety
- Regulatory and safety notices
- Product description and intended use
- Remove the front cover
- Prepare for bead chain size #10, 4.5mm
- Prepare support wall for cord loop and small size bead chains
- Prepare for cord loop D30, K35, C30, 2.7-3.5mm
- Prepare for vertical blinds track cord, bead chain size #6 and size #8
- Mount device to wall
- Charing the battery
- Set limits
- Set favorite position
- Set speed
- Set energy mode
- Pair with Android or iOS app
- Remove pairing
- Reboot the device
- Factory reset
- Technical specifications
2021-v1-en, main user manual MOVE motor pro
6
Outside device overview
1. 2.4” display with touch
2. Micro USB type B charge port
The touch display is used to access the different settings and adjust the position of the window cover where the MOVE device is
installed.
The MOVE devices can either be controlled directly at the device through the touch display, through a remote control or through
an app running on a smartphone or tablet. The remote control can be used with or without the app to control MOVE devices.
MOVE devices count the number of rotations the motor makes to know where open and closed limits for the window covers are
set and where the window cover are in between the open and closed limit. The limits need to be manually set at first use of
MOVE device. It is described in this user manual how to set limits.
Slippage or skipping by cord loop or bead chain can make the limits drift or get wrong. If these happens the limits need to be
adjusted for MOVE devices to know where the correct open and closed position are. Adjusting the limits are done the same way
as setting then the first time.
The open and closed limit are stored in the MOVE device. No matter what interface that is used to control the MOVE device it
will always just run in between the open and closed position, never outside of this range. But limits can for different reasons
become wrong and if that happens the motor will go pass the position it was set to stop at. This can be caused by many
different external factors. When the motor go pass a position it was supposed to stop at the root case should be determined and
fixed, then both open and closed limits should be set again.
Each MOVE device can have a favorite position that can be anywhere in between fully open and fully closed. It is described in
this user manual how to set a favorite position.
It is possible to set automations to trigger a MOVE device to go to any position in between fully open and fully closed.
Automations are stored and handled in each device separately.
It is possible to group MOVE devices and send commands that should be performed by all devices in a group. A single MOVE
device can belong to 8 different groups.