User's Manual
Table Of Contents
- Warnings and general precautions for safety
- Regulatory and safety notices
- Product description and intended use
- Remove the front cover
- Prepare for bead chain size #10, 4.5mm
- Prepare support wall for cord loop and small size bead chains
- Prepare for cord loop D30, K35, C30, 2.7-3.5mm
- Prepare for vertical blinds track cord, bead chain size #6 and size #8
- Mount device to wall
- Charing the battery
- Set limits
- Set favorite position
- Set speed
- Set energy mode
- Pair with Android or iOS app
- Remove pairing
- Reboot the device
- Factory reset
- Technical specifications
2021-v1-en, main user manual MOVE motor pro
8
Inside device overview
1. Front cover
2. 2.4” display with touch
3. Micro USB type B charge port
4. LiPo battery 7.4V 2600mAh
5. Wall screw slot
6. Wall screw slot
The front cover needs to be removed when installing the MOVE device.
The slot screw holes (5 and 6) are supposed to be used when installing the MOVE device. Screws and anchors are included in the
package but depending upon the wall where the device is intended to be installed, different type of screws and anchors may
need to be used.
The reason for the slot holes is that it is important that the MOVE device is installed with correct tension of the cord or bead
chain. It should not be too much nor too little tension. The slot holes make it possible to adjust the tension level even after the
screws are attached to the wall.
When the mounting to the wall is complete the front cover only needs to be snapped back on.
It is much easier to snap off the front cover when a MOVE device is mounted to the wall than it is to snap off a cover from a
MOVE device that is not attached to a wall.