User guide

OPERATION

Operation

1 Switch on the audio source (TV set or audio component) that the trans-

mitter is connected to, the green audio signal indicator LED will glow

constantly.

2 Switch the On/Off switch on the headset receiver to ON position. The

Green Signal indicator LED blinks. It will light steadily when the headset

receives the audio signal from the transmitter.

3 Adjust the volume for desired sound level, then place it on the head.

4 Select the preference of sound features (Standard, Treble, Mixed of Treble

and Bass, Bass) by pressing the sound enhancement button. "Beeps" will

be heard for every press of the button in the pressing cycle:

1 short beep: bass and treble enhanced

2 short beeps: treble enhanced

3 short beeps: bass enhanced

1 long beep: standard.

5 Adjust the left and right side volume using the volume control knobs to suit

the individual ear hearing balance level requirement.

Note: When the battery level is low you will hear 1 short beep every

minute in the headset receiver and the red power indicator LED will blink

slowly. After about 4 minutes you will hear a double beep sound and the

headset receiver will be switched off automatically.

Recharge the batteries or replace them with the fully charged spare bat-

teries.

Hearing damage due to high volumes!

This receiver allows you to set higher volumes than conventional head-

phones. This can cause hearing damage in persons with healthy hearing

and especially in children.

• Before putting the receiver on, set the volume on the receiver to a low

value.

• Do not continuously expose yourself to high volumes.

Helpline UK 0844 800 6503

(See page 29 for costs and hours of operation)