Instruction manual

AMPDIO DRIVERS
Page 27
2.3.6.2 ISA Card
To install an ISA ADIO card in Windows 95, 98 or ME do the following:
1. Go to the Control Panel by pressing START >
Settings > Control Panel.
2. Double click on the ‘Add New Hardware’ icon. Then
press ‘Next’.
3. To the question ‘Do you want Windows to search for
your new hardware?’ select ‘No’ then press ‘Next’.
4. Select ‘Amplicon Analogue Digital IO Counter Timer
Cards’ if it exists, otherwise select ‘Other’. Press
‘Next’.
5. Press ‘Have Disk’ then ‘OK’ and browse to the root
directory on the SOFTMAN CD, where the file
AMPDIO.INF should be located (AMPDIOV4.INF for
versions prior to v5.00). Alternatively, browse to the
directory on your hard disk where the AmpDIO
software was installed to (e.g.
C:\AMPLICON\AMPDIO).
6. Select from the list the card type you have just
installed then press ‘Next’.
7. Make a note of the settings Windows has defaulted the card to (I/O Range and Interrupt) then
press ‘Next’, then ‘Finish’.
8. If the Windows default settings match the card’s
jumper settings then allow Windows to reboot
(installation is now complete) else carry on with the
following :
9. If the Windows default settings do not match the
card’s jumper settings, do not reboot yet. Go to
START > Settings > Control Panel.
10. Double click the ‘System’ icon in the Control Panel
window and then select the ‘Device Manager’ tab on
the System Properties page.
11. Double Click on ‘Amplicon Analogue Digital IO
Counter Timer Cards’.
12. Click on your card.
13. Select Properties > Resources.
14. In 'Settings Based On' change from ‘Basic
Configuration 0’ to ‘Basic Configuration 1’.
15. Click on each item that needs to change, press
‘Change Setting’ and edit the item’s value.
16. When you are happy with the settings, Click OK and
allow Windows to REBOOT.