User guide

BATTERY INSTALLATION / SET-UP

INSTALL POWER SUPPLY IN ALL COMPONENTS

IMPORTANT! Do not mix battery types or attempt to recharge alkaline batteries.

Equipment damage, safety hazard or fire could result. Remove batteries if the unit

is not going to be used for long periods of time to prevent leakage.

SW3240 / SW3250: Both lecterns run on AC power or battery power. The battery

carriage holds 10 D-cell alkaline batteries or Amplivox optional S1465 NiCad

Battery Pack (Fig.1) which also requires a S1460 AC adapter for recharging. (Fig.

2). Or runs on a 12 Volt DC adapter (automotive cigarette lighter plug-in, not

included).

Locate amplifier (A). Loosen four thumbscrews (B) and remove battery door.

Remove battery carriage (C). Insert 10 D-cell alkaline batteries, observing polarity,

or replace with fully charged S1465 NiCad battery pack. Carefully replace the

battery carriage. Reposition battery door and fasten the thumbscrews.

Transmitter Bodypack: The transmitter bodypack (S1690T) is operated by

1 - "AA" alkaline battery. Before use, install battery as shown (Fig. 3). Make

certain the battery is fully seated in its compartment so the cover slides in place

easily. Battery life with alkaline batteries is approximately 8 hours of operating

time.

INTERNAL

WIRELESS

MICROPHONE

RECEIVER:

Select channel (1-16) on front panel (A). Channel number should match channel

number on wireless transmitter. Use supplied screwdriver to select channel number.

Frequency Range: 584-608 MHz

MICROPHONE TRANSMITTER (S1690T)

1) Rotate the Channel Selector Switch (

) to the desired channel with a small screwdriver. Channel must match channel selected

on receiver.

2) Belt clip on the back of the unit clips the transmitter onto a belt or the transmitter simply can be put into a pocket.

3) Plug the microphone into the Mic Input Jack (C).

4) The microphone can be clipped to a necktie or other clothing, using the supplied clip. The lapel mic should be placed under the

chin, as close to the center of the body as possible

5) Slide the power ON/OFF switch (D) to the ON position (the LED indicator light will illuminate). Please note that this is a 3

position switch. The center position is "MUTE".

Channel Selector Top Panel

NiCad Battery Pack (S1465) AC Adapter (S1460)

Fig. 1 Fig. 2 Fig. 3