User guide
2
SW915 DIGITAL AUDIO TRAVEL PARTNER
GettinG Started/Quick Setup (alSo printed on Battery cover)
1. Power unit on with rocker switch. The display will light
with MASTER VOLUME indicated.
Display will go black after one minute’s inactivity to
preserve battery power. Display will illuminate with a
press of any button.
2. Use the remote or the UP and DN buttons on the control
panel, to select a function.
3 To change the level of a selected function, press the
ADJUST button. ADJ will appear on the display. Press UP
or DN button to obtain desired level, then press SAVE.
4. Use UP and DN buttons to cycle through BASS, TREBLE,
DUCKING, REVERB, VOICE, and all VOLUME controls; then
ADJUST and press SAVE.
5. UHF Wireless MIC - To turn receiver on - Press and hold the
SET button for about two seconds. The current channel
will flash three times quickly; then the system will begin
to scan for the next open channel. When it finds an open
channel, it will flash the open channel three times and
then set the channel.
To turn transmitter on - Before turning on the transmitter,
use the provided screwdriver to set the transmitter channel
selector switches to the same number that is displayed on
the receiver. Select channels 1-8.
6. BATT STAT indicator - Red = no battery power, Yellow = 1
hour left. Charge battery overnight for best results.
If you need further assistance, please call 1-800-267-5486,
8am-6pm M-F CST.
PLEASE NOTE: THE REMOTE DOES NOT TURN THE UNIT ON OR OFF.
YOU MUST DO THAT ON THE CONTROL PANEL
ATTENTION:
ALL SAFETY AND OPERATING INSTRUCTIONS SHOULD BE READ
BEFORE OPERATING APPLIANCE. ALL OPERATING AND USE INSTRUCTIONS
SHOULD BE FOLLOWED WHEN OPERATING THE APPLIANCE. HEED AND
ADHERE TO ALL WARNINGS ON THE APPLIANCE AND IN THE OPERATING
INSTRUCTIONS. RETAIN ALL SAFETY AND OPERATING INSTRUCTIONS FOR
FUTURE REFERENCE.
WATER & MOISTURE -
DO NOT USE THE APPLIANCE NEAR WATER; IE.
BATHTUB, WASHBOWL, KITCHEN SINK, LAUNDRY TUB, WET BASEMENT OR
SWIMMING POOL.
HEAT -
SITUATE THE APPLIANCE AWAY FROM HEAT SOURCES SUCH AS
RADIATORS, HEAT REGISTERS, STOVES OR OTHER APPLIANCES (INCLUDING
AMPLIFIERS) THAT PRODUCE HEAT.
POWER SOURCES -
CONNECT THE APPLIANCE ONLY TO A POWER SUPPLY
TYPE DESCRIBED IN THE OPERATING INSTR-UCTIONS OR MARKED ON THE
APPLIANCE. GROUNDING OR POLARIZATION - PRECAUTIONS SHOULD BE TAKEN
SO THAT THE GROUNDING OR POLARIZATION MEANS OF THE APPLIANCE ARE
NOT DEFEATED. POWER CORD PROTECTION - POWER SUPPLY CORDS SHOULD
BE ROUTED SO THAT THEY ARE NOT LIKELY TO BE WALKED ON OR PINCHED BY
ITEMS PLACED UPON OR AGAINST THEM, PAYING PARTICULAR ATTENTION TO
CORDS AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY
EXIT FROM THE APPLIANCE.
PRODUCT PRICES, FEATURES, SPECIFICATIONS AND
AVAILABILITY ARE SUBJECT TO CHANGE WITHOUT NOTICE.
OBJECT & LIQUID ENTRY -
CARE SHOULD BE TAKEN SO THAT OBJECTS DO
NOT FALL AND LIQUIDS ARE NOT SPILLED INTO THE ENCLOSURE THROUGH
OPENINGS.
DAMAGE REQUIRING SERVICE -
THE APPLIANCE SHOULD BE SERVICED
BY QUALIFIED SERVICE PERSONNEL WHEN: (A) THE POWER SUPPLY CORD OR
THE PLUG HAS BEEN DAMAGED (B) OBJECTS HAVE FALLEN OR LIQUID HAS
BEEN SPILLED INTO THE APPLIANCE (C) THE APPLIANCE HAS BEEN EXPOSED
TO RAIN (D) THE APPLIANCE DOES NOT APPEAR TO BE OPERATING NORMALLY
OR EXHIBITS A MARKED CHANGE IN PERFORMANCE (E) THE APPLIANCE HAS
BEEN DROPPED OR THE ENCLOSURE DAMAGED.
SERVICING -
THE USER SHOULD NOT ATTEMPT TO SERVICE THE APPLIANCE
BEYOND THAT DESCRIBED IN THE OPERATING INSTRUCTIONS. ALL OTHER
SERVICING REFER TO A QUALIFIED SERVICE PERSONNEL.
important Safety inStructionS
NEED HELP?
CALL 800-267-5486
EMAIL:
CUSTOMERSERVICE@
AMPLI.COM